EC Line EC-2D Spezifikationen PDF herunterladen (Seite 74)

Chapter 7 Symbologies

Introduction

This chapter describes symbology features and provides the programming bar

codes for selecting these features.

The device is shipped with the settings shown in the Symbology Default Table

If the default values suit requirements, programming is not necessary.

There are two ways to change a parameter value:

! Scan the appropriate bar codes in this guide. These new values

replace the standard default values in memory.

! For SSI and USB SNAPI hosts, send a “parameter send” command

from the host system. Hexadecimal parameter numbers are shown

in this chapter below the parameter title, and options are shown in

parenthesis beneath the accompanying bar codes. See the Simple

Serial Interface (SSI) Programmer’s Guide for detailed instructions

for changing parameter values using this method.

Note: Most computer monitors allow scanning the bar codes directly on the

screen. When scanning from the screen, be sure to set the document

magnification to a level where the bar code can be seen clearly, and bars

and/or spaces are not merging.

To return all features to default values, scan the Set Default Parameter bar

code. Throughout the programming bar code menus, default values are

framed.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 191 192

Keine Kommentare

EC Line EC-2D Spezifikationen Seite 74